Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 59)

Installing the Handle Kit

Models FlexTest® IIm/GT/SE Controller Hardware Installation

Handle Kit

1. Place one support arm (1) into one handle side leg (2), as shown in the

handle kit assembly figure.

2. Set one of the clips (3) in place over the slender, straight portion of the

support arm (1), just behind the circular end of the support arm.

3. Insert two washers (4) and a screw (5) through the mounting hole in the

handle side leg (2).

4. Insert a spring (6) and a button (7) into the handle side leg mounting hole,

over the screw (5) and washers (4).

5. Press the button (7) into the handle side leg, as far as you can and push a

ratchet (8) over the button (7) leg detentes, until it snaps into place over the

first set of detentes. Make certain the burred or sharper edges of the ratchet

are pointing toward the handle side leg.

6. Hold a ratchet housing (9) in place over the ratchet (8) and press the posts on

the back side of the ratchet housing (9) into the mounting holes on the side

panel of the controller.

12 (handle-not shown)

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 59