Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 204)

Models FlexTest® IIm/GT/SE Controller Hardware

Cabling and Programming External Controllers

FlexTest IIm Controller Connections

204

Cabling and Programming External Controllers

Cabled properly, you can use your FlexTest controller to send test commands to

another controller. For detailed setup information, see “How to Program an

External Controller” on page 204.

When programming Series 2200 and 2400 Eurotherm temperature controllers,

the FlexTest IIm controller supports a special serial connection and software

setup. For more information, see “Programming Eurotherm Temperature

Controllers” on page 209.

How to Program an External Controller

To send programming to an external controller, you must:

1. “Cable the controllers.” on page 204.

2. “Create your configuration file with Station Builder.” on page 207.

3. “Adjust the signals with Station Manager.” on page 207.

4. “Set up your program.” on page 208.

Cable the controllers.

Standard Configuration For a standard configuration (using the Model 498.65 ADDA module), cable the

analog inputs and outputs between your FlexTest controller and the external

controller. Analog I/O connectors are located on the rear of the test processor

chassis.

1. Connect a Series 498 Analog Out connector to the external controller

program (analog) input.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 204