Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 206)

Models FlexTest® IIm/GT/SE Controller Hardware

How to Program an External Controller

FlexTest IIm Controller Connections

206

Note Analog I/O connectors are located on the rear panel of the Series 498

test processor chassis.

1. Connect a 493.82 Analog Out BNC connector to the external controller

program (analog) input.

2. If you will monitor sensor feedback for data acquisition or control feedback,

connect the external conditioner output to a 493.83 Filtered Analog Input

BNC connector.

For conditioner output locations on various MTS devices, see “Sample

conditioner output connections” on page 207.

Transition Module Connections

Transition modules on the rear panel of the

Series 498 test processor chassis are used for

analog inputs and outputs.

493.83 Filtered Analog Input

This module includes 8 BNC

connectors that provide filtered

analog inputs to the Model

493.55 A/D mezzanine cards.

Eight analog inputs are

available with the each A/D

mezzanine card installed on

the Model 493.50 ADDA II

module.

493.82 Analog Out

This module includes 8 BNC

connectors that provide analog

outputs from a Model 493.56 D/A

mezzanine card.

Eight analog outputs are available

with each D/A mezzanine card

installed on the Model 493.50

ADDA II module.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 206