Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 197)

Digital I/O Connections

Models FlexTest® IIm/GT/SE Controller Hardware FlexTest IIm Controller Connections

197

Digital inputs • Digital inputs can be wired to allow the input from a switch contact, a relay

contact, or a logic signal.

• All digital inputs are optically isolated at the Series 498 Digital I/O

transition module.

• For example, an action defined in the can be selected, in the Station Setup

window’s Digital Input panel, as an Action.

• The digital inputs are used by the Digital Input process in the MultiPurpose

TestWare application. They can also be monitored from the Station Manager

application.

• You can use the Event-Action Editor window to define an action that occurs

in response to a digital input event. The defined action can then be selected

in the Station Setup window’s Digital Input panel.

• Sixteen jumpers located on the Series 498 Digital I/O transition module allow

each input to be configured for a relay contact or logic signal.

• Each digital input connector on the built-in Digital I/O Access panel (FlexTest

IIm) supports two channels.

• Each digital input supports a differential TTL to +30 V DC signal or a

switch or relay contact switching the on-board 12 V supply.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 197