Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 239)

Eurotherm Temperature Controller Connection

Models FlexTest® IIm/GT/SE Controller Hardware FlexTest SE Controller Connections

239

Eurotherm Temperature Controller Connection

Automated FlexTest SE Controllers can program and control a single Eurotherm

temperature controller.

Note Stand-alone FlexTest SE Controllers are not equipped for use with

temperature controllers.

To use a temperature controller with a FlexTest SE Controller:

1. Configure the FlexTest SE Controller’s Debug Serial Port.

2. Cable the temperature controller to the FlexTest SE Controller.

3. Add a temperature controller resource to the hardware interface file (hwi).

4. Add a temperature control channel to the station configuration file.

Configuring the Debug

Serial Port

To use a FlexTest SE Controller with a temperature controller, configure the

Debug Serial Port as follows:

1. Access the Model 498.96 Processor circuit card in the Controller’s chassis.

2. Locate switch S3.

3. Set bit 8 to the off (open) position.

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 239