Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 42)

Models FlexTest® IIm/GT/SE Controller Hardware

Installing the Plug-in Modules

Installation

Installing the Plug-in Modules

This section describes how to install the plug-in modules into the chassis. The

modules plug into a backplane connector and are secured to the chassis with a

screw at the top and at the bottom of the module faceplate.

A hardware interface file (.hwi file extension) defines each type of module and

maps each module location for the system software. The .hwi file and the

physical locations for each type of module must match. Recommended standard

module locations are described in the following sections. For more information

on the .hwi file, see the Hwi File Editor manual.

The plug-in modules contain static-sensitive components.

Improper handling of the module can cause component damage.

Be sure to follow these precautions when handling modules:

• Turn off electrical power before installing or removing a module.

• Use a static ground strap to ground yourself to the chassis ground

before touching the chassis or a module.

• Keep unused modules in conductive bags. Also be sure you are

grounded when removing a module from a conductive bag.

• Handle modules with their front panel or circuit card edges. Do not

touch any circuit card components, pins, or circuit connection points.

CAUTION

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 42