Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 243)

Models FlexTest® IIm/GT/SE Controller Hardware Hydraulic Configurations

243

Appendix A

Hydraulic Configurations

This section describes how to connect the Model 493.10 Chassis (FlexTest GT

Controllers) and the Model 493.02 Chassis (FlexTest SE) to a variety of MTS

hydraulic configurations.

Use the following connectors and cables to connect the Model 493.10/02 Chassis

to your HPU with a Model 493.07 Converter Box:

Note For jumpering information, see Appendix B: Model 493.07 Converter Box

on page 251.

Models 493 Chassis to

493.07 Converter Box

• 15 contact type D female EMI connector at J25 of the Model 493.73 HPU

Transition module in the rear panel of the Model 493.10 Chassis.

Backshell–EMI metallized plastic.

• 14 contact type CPC male connector at J1 of the Model 493.07 Converter

Box chassis.

• Cable–24 AWG 10 conductor with overall foil shield, (Carol C0745 or

equivalent) with drain wire connected to metallized plastic backshell at the

493.10 chassis, and pin 14 at the Model 493.07 Controller Box chassis.

Model 493.07 Converter

Box to HPU

• 24 contact type CPC female connector at J25 of the Model 493.07 Converter

Box chassis.

• 14 contact type MS connector at J1 of the HPU.

• Cable—18 AWG 14 conductor with overall foil shield, (Alpha 2248C or

equivalent) with drain wire connected to pin 4 of connector J25 and pin A of

the pump connector.

Hydraulic pump

configurations

The following diagrams show how to connect the chassis to a hydraulic power

unit.

• Single 493 chassis with a 24 V PLC (programmable logic controller) pump

or 505 pump

• Single 493 chassis with a non-PLC pump

• Multiple 493 chassis with a non-PLC pump

• Compatible controllers controlling a pump

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 243