Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 49)

Installing the Plug-in Modules

Models FlexTest® IIm/GT/SE Controller Hardware Installation

Installing the 493.02 Chassis (FlexTest SE)

This section describes how to install the MTS FlexTest 493.02 chassis and

connect it to your system components.

Contents Installing the Plug-in Modules 42

VMEbus Modules 50

Chassis Installation Options 51

Connecting Electrical Power 53

Installing the Handle Kit 58

Installing the Plug-in Modules

This section describes how to install the plug-in modules into the chassis. The

modules plug into a backplane connector and are secured to the chassis with a

screw at the top and bottom of the faceplate.

The plug-in modules contain static-sensitive components.

Improper handling of the module can cause component damage.

Be sure to follow these precautions when handling modules:

• Turn off electrical power before installing or removing a module.

• Use a static ground strap to ground yourself to the chassis ground

before touching the chassis or a module.

• Keep unused modules in conductive bags. Also be sure you are

grounded when removing a module from a conductive bag.

• Handle modules with their front panel or circuit card edges. Do not

touch any circuit card components, pins, or circuit connection points.

CAUTION

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 49