Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 253)

Models FlexTest® IIm/GT/SE Controller Hardware Chassis Maintenance

253

Appendix C

Chassis Maintenance

This section describes how to maintain your MTS controller chassis.

Cleaning the chassis Remove any dust from the chassis with Endust for Electronics or equivalent.

Cleaning the air filter Be sure the cooling fan is operational and not clogged. Clean or replace the filter

as required.

The filter is typically located in the top of the chassis, and can be accessed from

the rear.

To clean the air filter:

1. Remove the filter from the chassis.

2. Immerse the filter in a large pan filled with warm water and a mild

detergent, and allow it to soak a few minutes.

3. Gently agitate the filter to loosen debris.

4. Rinse the filter thoroughly with clean water.

Note Do not use compressed air to help dry the filter. Compressed air may

damage the filter element.

5. Allow to drip until completely dry.

Note The air filter has a distinct top and bottom. Ensure that you orient the

filter properly.

6. Replace the filter in the chassis.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 253