Mts Model FlexTest SE Manual do Utilizador descarregar pdf (Página 201)

Encoder/Temposonics Connections

Models FlexTest® IIm/GT/SE Controller Hardware FlexTest IIm Controller Connections

201

Jumper configurations The Series 498 transition module can be configured for a Temposonics sensor, a

5 V DC encoder, a 12 V DC encoder, a 24 V DC encoder. The following is a list

of the configuration drawings:

• 049-035-301 Absolute Encoder

• 049-035-401 +5 Volt Encoder

• 049-035-501 +12 Volt Encoder

• 049-035-601 +24 Volt Encoder

• 049-035-701 Temposonics II

• 053-070-201 Temposonics III

ADDA mezzanine

cards

The ADDA module requires special mezzanine cards to support encoders and

Temposonics sensors.

Mezzanine cards for encoders and Temposonics sensors support four input

channels.

Mezzanine cards for multiturn encoders (Heidenhain 417/425) and Temposonics

III position sensors support two channels.)

• The encoder mezzanine card counts pulses from the encoder to determine

the displacement of an actuator.

• The Temposonics mezzanine card interprets the pulses from the

Temposonics sensor to determine the displacement of an actuator.

Optional ADDA II

configuration

For the optional ADDA II configuration (using the Model 493.50 ADDA II

module), each encoder requires installation of a Model 493.59 Universal Encoder

mezzanine card on the Model 493.50 ADDA II module.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 263 264

Sem comentários

Mts Model FlexTest SE Manual do Utilizador Página 201