Mts TestLine Manual do Utilizador descarregar pdf (Página 120)

AnnuallyBiweeklyWeeklyDailyCalendar Time using 8 hour Running

Time rate per day

2,0001,500100050080408Running Time-Hours

MTSMTSMTSMTSCheck response to full stroke waveform,

visual and audible.

MTSMTSMTSMTSCheck displacement control valve balance.

MTSMTSMTSMTSCheck valve dither response.

Maintenance Intervals

The following table lists the recommended interval for each of these procedures.

Load Unit Maintenance Intervals

When to Do ItWhat to Do

Before the start of each day’s testing.Make daily inspections.

Depends on the operating environment; more often

in humid environments.

Take rust prevention precautions.

At least once a month.Perform label inspection.

After actuator or force transducer installation; when

a better alignment between the two is desired.

Align the force transducer.

At least once a month; more often as required by

operating conditions.

Check the accumulators’ precharge pressures.

Adjust if necessary.

Weekly; more often as required by operating

conditions.

Clean exposed actuator piston rod.

When the indicator is in bypass position or when

hydraulic fluid is changed.

Change HSM filter.

When servovalve performance has deteriorated.Perform Model 252 Servovalve maintenance:

change filter.

120 | MTS TestLine Test System Operation

Maintenance

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 131 132

Sem comentários

Mts TestLine Manual do Utilizador Página 120