Mts 709 Alignment System Manual do Utilizador descarregar pdf (Página 99)

709 Alignment System Alignment Wizard

The alignment wizard is a graphical tool that shows you in real time what

adjustments need to be made. You bring up the alignment wizard by clicking the

Alignment Wizard button on the Align tab. It shows which particular

adjustments need to be made based on which ones are most out of adjustment.

If Auto Select Angular Or Concentric is checked,

the wizard will automatically switch to show which

adjustment is most out of alignment. If this is not

checked, you can switch back and forth using the Go

To Concentric and Go to Angular buttons. In either

case, the Tighten and Loosen arrows will always

show which adjustment is most out of alignment.

If Play Audio For Screw To Tighten is checked, a

synthesized voice will tell you which screw should be

tightened.

The entry in the Samples To Wait Between Stop

And Next Instruction field specifies the number of

samples the software will wait once the symbol has crossed (green crosses zero or red crosses blue)

before determining the next adjustment instruction to tighten/loosen the appropriate setscrew. This is

useful because the bending strain often springs back once the wrench is removed, so the wait allows

the bending strain to settle such that the worst misalignment component can be properly determined.

The entry in the Points in History Trail field is the same as the similar entry on the Options tab; see

“Align Bending Chart” on page 72. The number of history trailing points can be edited either here or

on the Options tab.

Clicking the Close button will close the Alignment Wizard.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 157 158

Sem comentários

Mts 709 Alignment System Manual do Utilizador Página 99