Mts Multi-Pump Control Manager Manual do Utilizador descarregar pdf (Página 15)

Placement of Components

Multi-Pump Control Manager Installation

Installation

The Multi-Pump Control Manager (MPCM) allows you to operate up to eight

Hydraulic Power Units (HPUs) remotely. Standard installation involves

placement of the components and cabling connections.

Placement of Components

Because all connections between components run through the Basic Connection

Interface (BCI), it is usually placed in a central location; typically next to the

HPUs.

The dedicated PC running the Supervisor software is usually placed in the

control room.

Station Flow Managers (SFMs) are usually placed in alternate control rooms or

next to the test rig.

Remote E-Stops are usually placed at strategic locations, such as near exits from

the test rig.

Light stacks are strategically placed to be able to observe alarm and fault status in

case problems arise that require attention.

Mount the BCI

Four mounting brackets are provided on the BCI: two top and two bottom. Mount

the BCI using hardware that can support 50 kg (110 lbs); including the weight of

the BCI and attached cables.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sem comentários

Mts Multi-Pump Control Manager Manual do Utilizador Página 15