Mts SWIFT 40 Sensor Manual do Utilizador descarregar pdf (Página 86)

SWIFT 40 Sensors

Test Track Vehicle

Installing the Transducer

Note If the anti-rotate assembly interferes with the mounting of the digital

inclinometer, use the alternate mounting location shown.

D. Place the digital inclinometer on the bracket and rotate the tire until the

inclinometer reads 0.0°, ±0.1° (or 90°, ±0.1° if the alternate position is

used).

E. Push the Bridge Zero button on the front of the TI box. The LED will

turn on for a few seconds, then start blinking rapidly. The Angle Zero

indicator will start blinking slowly.

F. Remove the digital inclinometer and level bracket.

G. Rotate the tire 90° in either direction.

H. Attach the level bracket so that it again sits on top of the transducer.

Insert the locking pin through the bracket and into the pin pilot hole on

the transducer.

S40-20

Digital Inclinometer

in this position

should read 0°, ±0.1°

Level Bracket

Insert Lock Pin

in Pilot Hole

Axes

Icon

Digital Inclinometer

(alternate location)

in this position

should read 90°, ±0.1°

S20-21

Angle Zero

Switch and Indicator

Bridge Zero

Switch and Indicator

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 169 170

Sem comentários

Mts SWIFT 40 Sensor Manual do Utilizador Página 86