Mts SWIFT 10 MC Sensor Manual do Utilizador descarregar pdf (Página 53)

Edit the Calibration File

SWIFT 10 MC Sensors Setting up the Transducer Interface

Edit the Calibration File

The calibration file contains offset values for all of the bridge outputs.

Changing any of the items other than those listed in the following procedure

will cause your calibration file to be incorrect.

Take care not to change any values except those listed in the following procedure.

If your calibration file is incorrectly changed, reload the original file from the

diskette provided by MTS.

1. Open the calibration file using a text editor.

Typically two calibration files are provided with each transducer: one for

spinning applications and one for non-spinning (fixed) applications.

The spinning application files are usually names in the format <transducer

serial number>s.cal.

The non-spinning (fixed) application files are usually names in the format

<transducer serial number>f.cal.

CAUTION

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 143 144

Sem comentários

Mts SWIFT 10 MC Sensor Manual do Utilizador Página 53