Mts Material Test Systems Manual do Utilizador descarregar pdf (Página 20)

DescriptionItem

Environmental Accessories1

1A. High temperature furnace

1B. Environmental chamber

1C. Temperature controller

Extensometers2

Alignment accessories3

3A. High temperature furnace

3B. Environmental chamber

Remote station control4

Remote E-Stop (optional)5

Test area guard6

Grips and bend fixtures7

3.2.1.0 Load Frame Test Controller

The test controller can be either a FlexTest SE Basic, FlexTest SE Plus, FlexTest GT, or FlexTest

40/60/100/200.

Note:

Because the FlexTest 40 is the most common test controller used on the MTS Landmark System, this

manual will primarily focus on that controller.

The FlexTest 40, FlexTest SE Plus, and FlexTest SE 2-Channel are single station PC-based digital controllers.

The FlexTest 60/100/200 controllers are PC-based multi-station digital controllers. In more complex testing

situations, the multi-station controller controls many channels on a number of independent stations; with one

or more of the stations being a load frame based test system. These test controllers consist of:

• A PC running Series 793 Software (except the FlexTest SE Basic).

• A chassis equipped with Series 493 or Series 494 electronics.

• A handset for load frame control during specimen loading and unloading. The handset is also used for

setup and can initiate tests at the load frame.

• The Station Manager application running on the PC as the primary test interface.

• A software application (such as MultiPurpose TestWare) to provide the command and data acquisition

functions of running a test.

The FlexTest SE Basic is nonautomated and operates from the front panel controls.

20 MTS Material Test System Operation

3.0 Introduction

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Sem comentários

Mts Material Test Systems Manual do Utilizador Página 20