Mts Criterion Series 40 Manual do Utilizador descarregar pdf (Página 31)

DescriptionControl / Screen / LEDNumber

Makes fine adjustment of the crosshead. Moving the wheel

towards the display moves the crosshead up; moving the

Thumb-Wheel4

wheel away from the display moves the crosshead down. The

handset must be enabled for the thumb-wheel to be active.

Pauses the test action. Press this button again for the test to

resume. Testing software must be active.

Pause5

Stops the test action. Testing software must be active.Stop6

RJ-45 connection to the controller.Connector7

Returns the crosshead to the original position (zero point).Crosshead Return8

Starts the test action. Testing software must be active.Start9

Moves the crosshead in the downward direction while

depressed. Handset must be enabled.

Crosshead Down10

Moves the crosshead in the upward direction while depressed.

Handset must be enabled.

Crosshead Up11

When illuminated, indicates an active fault or interlock.Fault12

Used to enable/disable the handset. When the indicator is

illuminated, the handset is enabled to control movement of

the crosshead.

Handset Enable13

Shows four lines, 20 characters per line.Display14

Safety Enclosure (Optional)

The optional safety enclosure is used to avoid projectile hazards and to facilitate safe system operation

by preventing body parts from entering crush zones during tests.

MTS Criterion

™

Series 40 | 31

System Introduction

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 141 142

Sem comentários

Mts Criterion Series 40 Manual do Utilizador Página 31