Mts Advantage Wedge Action Grips Manual do Utilizador descarregar pdf (Página 27)

Manual Name Operation

Installing a Specimen

The following procedure describes how to install a specimen in the MTS

Advantage Wedge Grips. This procedure assumes a set of wedges has been

properly installed.

The contact area between the grip face and specimen should be as large as

possible.

A small contact area between the grip face and specimen can cause

premature wear to the grip face surface.

MTS recommends that specimens should be machined to provide the largest

possible surface contact area between the grip face and the specimen.

CAUTION

Large contact area

recommended

Small contact area can

cause premature wear

and damage the grips

Wedge face

Contact area

Bottom gap

specification

(3-6 mm)

(H x W)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Sem comentários

Mts Advantage Wedge Action Grips Manual do Utilizador Página 27