Mts SWIFT 30 Sensor Manual do Utilizador descarregar pdf (Página 89)

Test Track Vehicle

SWIFT 30 Sensors Installing the Transducer

Note If the anti-rotate assembly interferes with the mounting of the digital

inclinometer, use the alternate mounting location shown.

D. Place the digital inclinometer on the bracket and rotate the tire until the

inclinometer reads 0.0°, ±0.1° (or 90.0°, ±0.1° if the alternate position

is used).

E. Push the Bridge Zero button on the front of the TI box. The LED will

turn on for a few seconds, then start blinking rapidly. The Angle Zero

indicator will start blinking slowly.

F. Remove the digital inclinometer and level bracket.

G. Rotate the tire 90° in either direction.

H. Attach the level bracket in the same orientation as in Step 7C.

Insert the locking pin through the bracket and into the pin pilot hole on

the transducer.

Digital Inclinometer

in this position

should read 0°, ±0.1°

Axes Icon

Insert Lock Pin

in Pilot Hole

Level Bracket

S30-20

Digital Inclinometer

(alternate location)

in this position

should read 90°, ±0.1°

S20-21

Angle Zero

Switch and Indicator

Bridge Zero

Switch and Indicator

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 171 172

Sem comentários

Mts SWIFT 30 Sensor Manual do Utilizador Página 89