Mts Multipurpose Elite Manual do Utilizador descarregar pdf (Página 70)

Digital IO Meter uses the corresponding “Turn on light” and “Turn off light” actions you created in Creating

Controller Resource Actions that Map to the Profile on page 64.

The keywords are placed in the profile so that the Digital IO Indicator lights only while the square wave portion

of the custom waveform plays out. Using this concept, you can cause the Digital IO Indicator to light during

the test as desired.

1. Click the Test-Run Display tab.

2. In the Toolbox panel, note the various monitor displays available. From the Interactive list, select the

Digital IO.

3. Drag the Digital IO icon to the work area, and position it as desired.

Note:

You can also double-click the Digital IO icon to place it on the Procedure work area.

4. Observe the error icon on the Digital IO Indicator in the Properties panel and in the Error list.This directs

you to select a resource for the Digital IO Indicator.

Note:

Except for the values listed in the next step, use the default selections.

5. Enter the following as necessary:

Digital IO Indicator Properties

ValueProperty

Digital Output 1Signal

24Font Size

For More Information

Creating Controller Resource Actions that Map to the Profile on page 64

6.2.10.0 Start the Test Procedure and Observe the Response

This task starts the test and shows test information on the monitor displays. The purpose of this task is to

observe command, counter, and action elements of the profile as it plays out.

1. Ensure that the station has power by turning on the HPU first. If an Interlock indicator is lit on the Power

panel, click Reset. Next, click the Low then High buttons for the HSM.

2. Click the New Test Run icon in the tool bar.

3. Observe the Specimen Selection window.This window pertains to the physical characteristics of your test

sample. Since this is a new test and no specimens used in prior test runs are available, select a new

specimen by clicking the Add New button.

4. Observe the new specimen selection with the following properties.

70 Multipurpose Elite Test Design Guide

6.0 Creating Advanced Tests

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 111 112

Sem comentários

Mts Multipurpose Elite Manual do Utilizador Página 70