Mts Series 793 Application Manual do Utilizador descarregar pdf (Página 114)

100

101

MTS MultiPurpose TestWare®

About Control-Mode Variables

Working with MPT Variables

114

About Control-Mode Variables

A control-mode variable is an enumeration variable that can be used to change

the control-mode parameter in multiple processes. After a control-mode variable

is assigned to a process’s control-mode parameter, any change to that variable

changes that process’s control mode.

This variable selection is manually set using the list in the Variable View window

or the Variables Editor when the test is not running. Control-mode variables do

not change during run time.

Supported processes The following processes support the use of variables to change the control mode:

• Cyclic Process

• Segment Process

• Dwell Process

• Sweep Process

• Cyclic ALC Process

Assign control-mode

variables

To assign a control-mode variable to a process, right-click in the process’s

Control Mode list and assign a control-mode variable.

Change control modes When the test is not running, use the Variable View window or the Variables

Editor to change the control-mode variable selection.

Any process control-mode parameter that uses that variable will change to reflect

the new control-mode variable selection.

A control-mode variable cannot be changed when the test is running.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 575 576

Comentários a estes Manuais

Sem comentários

Mts Series 793 Application Manual do Utilizador Página 114

Comentários a estes Manuais

Manuais e produtos relacionados com Software Mts Series 793 Application