Mts ReNew Technical Reference Manual do Utilizador descarregar pdf (Página 41)

ReNew Technical Reference Troubleshooting Guide

Troubleshooting Guide

Use this chapter to identify mechanical and electronic problems with your

ReNew and ReNew SMA Systems. To contact the MTS HELPLine and/or an

MTS Applications Engineer, see “Contacting MTS” on page 10.

Crosshead will not move • Load frame is not powered up (Limit switches on the crosshead are not lit up

red and/or the handset LCD is not on).

• One or both of the physical limits are tripped.

• Line voltage is too low or too high.

• If the crosshead moves with the handset:

– Computer/frame interface cable is loose or improperly connected.

– Improper machine parameters. Contact an MTS Applications Engineer

for further assistance.

• Remote power switch not in the On position.

• If the crosshead does not move with the handset:

– Unplug the handset and then reconnect it.

– Frame is in fault condition. Cycle the power to the frame.

– Other problem(s) with the test frame. Contact an MTS Applications

Engineer for further assistance.

Crosshead moves in

only one direction

• One of the physical limits is activated.

Crosshead always

moves at maximum

speed

• Controller not receiving position feedback. Contact an MTS Applications

Engineer for further assistance.

• Check the cables between the motor and the servo amp.

Crosshead stops

beyond where it should

have

• Incorrect machine parameters. Contact an MTS Applications Engineer for

further assistance.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 49 50

Sem comentários

Mts ReNew Technical Reference Manual do Utilizador Página 41